Greddy AIR INTAKE SYSTEMS: Honda Civic Si 2006-11 (CAI) Bedienungsanleitung

Instruction Manual P/N: 12559007Make: Honda Model: Civic Si Year: 2006-2011 Engine: L4-2.0L

Refer to Figure G for step 13Step 13: Remove five plastic clips on the driver side wheel well using a flat-head screwdriver. (This step should gi

Refer to Figure H for step14Step 14: Remove the two 10mm bolts/screws from the resonator then remove the resonator assemblyPage 11Figure HGReddy.com

Figure IMRefer to Figure I for step 15 Page 12Step 15: Screw in the isolation mount M where the stock bolt was located on the OE resonator tube

Refer to FigureJ for step 16-17Step 16: Remove the MAF sensor from the OE intake and place it into the GReddy intake tube. Using the (2) provided

Figure KJLKNCDIHStep 18: Place the 044 I and 048 H clamps onto the coupler and then place onto the throttle body. Do not tighten at thi

Refer to Figures K & L for steps 22-26Step 22: Connect the vacuum hose C from the GReddy tube to the crank case. Use the clamp J to tig

Pro DRY S Air FilterP/N: TF-9011D To purchase any of the items above, view airflow charts, dyno graphs, photos, and video, please go to GReddy.com.Pag

Page 17GReddy.com

Page left blank intentionally.

Page left blank intentionally.

Label Qty. Description Part NumberA 1 Pro Dry S Air Filter TF-9011DB 1 Intake Tube 05-T1004P2C 1 Hose, 5/8" (18.5") 05-00069D 1

P/N: 06-80610GReddy Performance Products9 Vanderbilt, Irvine CA 92618TEL: 949.588.8300 • E-Mail:[email protected]

B C D FEGM N OLKJIHPage 3AM N OGReddy.com

Refer to Figure A for steps 1-5Step 1: Unplug the harness from the MAF sensor 1Step 2: Remove the three 10mm nuts from the stock air box Step 3: U

Refer to Figure B for step 6Step 6: Be sure the vehicle is cold. Loosen the radiator cap and then remove entire crank case and coolant plenum line

Refer to Figure C for step 7Step 7: Replace the coolant line with the supplied heater hose E Be sure to tighten each end with a 004 mini clamp

Refer to Figure D for step 8Step 8: Remove the battery and battery tray from the vehicle. Be sure to have your radio code so that you can enter the co

Refer to Figure E for steps 9-11Step 9: Remove the positive wiring clip off of the bracket 1Step 10: Loosen the bolt connecting the bracket with the

Refer to Figure F for step 12Step 12: Remove seven plastic clips from lower facial (bumper) valance (drivers side) the one on the very end uses a